HomePlumbing ServicesFaucet and Shower Valve Repair
Faucet and fixture repair around Lone Oak, TX
Faucet Repair and Shower Valve Replacement
A dripping faucet, a shower that won't hold a temperature, or an outdoor faucet leaking down the side of the house all waste water and only get worse. On The Way Plumbing handles faucet repair, shower valve replacement, hose bibs, angle stops and appliance hookups for homes and businesses around Lone Oak, Hunt County and Rains County. We tell you what's wrong and what it costs before we start.
- 5.0 on Google from 354 reviews
- Texas license M-44817
- Family owned in Lone Oak, TX
- Free estimates, upfront pricing
- Emergency plumbers on call 24/7
Leaky faucet: why it drips and what fixes it
A leaky faucet is almost always a worn part inside the faucet, not a problem with the pipes. Which part depends on the style of faucet you have:
- Cartridge faucets. Most single handle kitchen and bath faucets use a cartridge. When its seals wear, the spout drips or water leaks out around the handle. A new cartridge usually fixes it.
- Ceramic disc faucets. Two hard discs slide against each other to control the water. The discs rarely wear out, but the rubber seals under them do, and grit can scratch the discs.
- Compression faucets. The older two handle style that you crank down to close. They use rubber washers and brass seats, and they drip when the washers harden or the seats get pitted.
- Ball faucets. A single handle with a rotating ball inside, found in plenty of older kitchens. Springs, seats and O-rings wear out.
Hard water speeds all of this up. Scale builds on cartridges and seals, makes handles stiff and lets water past. If you're replacing faucet parts every year or two, a water softener is worth a look.
A slow drip doesn't look like much, but it runs 24 hours a day, and dripping hot water means you're paying to heat water that goes straight down the drain. It's also a cheap fix when it's caught early, before a worn part damages the faucet body.
Faucet repair problems we fix
We repair kitchen, bathroom, laundry and bar sink faucets. These are the calls we get most.
Dripping from the spout
A worn cartridge, washer or seat. We match the part to your faucet and replace it, and clean out any scale while it's apart.
Leaking at the handle or base
Worn O-rings or a loose cartridge nut. Water that leaks at the base often runs under the faucet into the cabinet where you won't see it.
Low flow
Usually a clogged aerator full of scale or debris, especially after water line work. If cleaning the aerator doesn't help, a clogged cartridge or a bad supply line is next on the list.
Stiff or loose handle
Scale inside the cartridge makes handles hard to turn. A loose handle is often a stripped set screw or worn adapter.
Leaks under the sink
A pull-down hose that's cracked, a sprayer hose, a supply line or a loose connection under the sink. Small leaks there swell cabinet floors and can lead to mold.
Faucet loose on the sink
A faucet that moves when you use it loosens its own connections over time. We tighten or reset the mounting hardware.
Repair or replace the faucet?
Most faucets are worth fixing if parts are available. We'd rather fix your faucet than sell you a new one you don't need. That said, replacement makes more sense when:
- The faucet body is cracked or badly corroded.
- You can't find parts for an old or off-brand model.
- You've already had it repaired more than once and it's still leaking.
- You want a different style, such as a pull-down kitchen faucet or a faucet that fits a new sink.
When we install a new faucet, we put on new supply lines, check the shutoff valves under the sink, and test for leaks above and below the counter. If the angle stops are old and won't close all the way, we'll tell you and give you a price to replace them at the same time, since it's easier with everything already apart.
Shower valve repair and replacement
The shower valve is the part behind the handle, inside the wall, that mixes hot and cold water. When it starts acting up, the fix is either a new cartridge or a full shower valve replacement.
Signs your shower valve has a problem
- The shower head drips after you turn it off.
- Temperature swings when someone flushes a toilet or runs the dishwasher.
- You can't get the water hot enough, or it gets too hot too fast.
- The handle is hard to turn or spins without changing anything.
- Water stains or soft drywall on the other side of the shower wall.
If you only lose hot water in the shower, it's usually the valve. If you lose it everywhere, the water heater is the more likely suspect.
Cartridge repair
Many shower problems are solved by replacing the cartridge, the same as a sink faucet. It's done from the front through the handle, without opening the wall. If the valve is a common model and the body is in good shape, this is the quickest fix.
Full shower valve replacement
A full shower valve replacement makes sense when the valve body is leaking, parts aren't available, or you're updating an old valve to a modern pressure balancing or thermostatic valve. A pressure balancing valve keeps the temperature steady when pressure changes elsewhere in the house, which protects against sudden scalding. A thermostatic valve holds a set temperature more precisely. Replacing the valve means getting to the pipes behind it, either through an access panel from the closet or room behind the shower, or through the tile. We'll look at both sides of the wall and tell you which way makes the least mess before we start.
Outdoor faucet and hose bib repair
Outdoor faucets (hose bibs) take a beating from sun, freezes and hoses being yanked around. Outdoor faucet hose bib repair is one of the most common fixture calls we get after a cold snap. These are the usual problems:
- Dripping from the spout. A worn washer or a bad stem, same as an old indoor faucet.
- Leaking from the handle. Worn packing around the stem.
- Leaking from the vacuum breaker. The little cap on top of many hose bibs spits water when its parts wear out. It's there to stop dirty water from siphoning back through a hose into your house, so it's worth fixing rather than removing. More on that on our backflow prevention page.
- Water inside the wall. A frost-free hose bib has a long stem that shuts off the water inside the warm part of the wall. If a hose is left connected during a hard freeze, the water trapped in the stem can't drain, freezes and splits the pipe. You often won't see the leak until the next time you turn the faucet on and water runs into the wall or the crawlspace.
We repair or replace leaking hose bibs, and we can swap standard bibs for frost-free ones. Before the next freeze, disconnect hoses and cover outdoor faucets. Our guide on preventing frozen pipes in winter has the rest of the list. If a pipe has already split, our burst pipe repair page covers what to do first.
Angle stops and supply lines
An angle stop is the little shutoff valve on the wall or floor under a sink or behind a toilet. It's what lets you turn off water to one fixture without shutting off the whole house. Most people never touch them until there's a leak, and that's when they find out the old valve is frozen open or starts dripping the moment it's turned.
Older multi-turn stops have rubber washers inside that harden and stick over the years. Quarter-turn valves are the usual replacement. They close with a quick turn of the handle and are much less likely to seize. At the same time, we check the supply lines. Old plastic or rigid lines get swapped for braided supply lines.
Janice F. had Chad and JB replace four angle stops under her kitchen sink, and they hooked up a new dishwasher on the same trip. That's a common pairing. If one valve under a sink is bad, the others are usually the same age.
Dishwasher and washer hookups
Appliance hookups look simple, but they're behind a lot of the leaks we find. Rene M. wrote in a review that both the hot and cold lines leaked when their washer was hooked up in their new home, and their inspectors hadn't caught it. Here's what a proper hookup covers.
- Washer hookups. Hot and cold valves in a washer box, a drain standpipe at the right height with a trap, and washing machine hoses in good shape. Rubber hoses crack and bulge with age. We check for that, and for valves that won't shut off.
- Dishwasher hookups. A water supply off the hot line under the sink with its own shutoff, and a drain hose with a high loop under the counter or an air gap, so dirty sink water can't drain back into the dishwasher.
- New laundry locations. Moving a washer or adding a laundry room means new supply and drain lines. Brett P. had Blake and his team out for a thorough estimate on washer and dryer hookups before any work started.
If you're seeing water on the floor near an appliance and can't tell where it's coming from, our leak detection service will find it.
What goes into the price of faucet and valve work
We don't post flat prices online because the same drip can be a cheap cartridge or a corroded faucet. We look first, then give you an upfront quote, and when there's more than one way to fix it, we give you the options. Estimates are free. The things that change the price:
- The part. A common cartridge costs less than a hard-to-find part for an older faucet.
- Access. A shower valve behind an access panel is a faster job than one behind tile.
- Add-ons. New angle stops, supply lines or a vacuum breaker done on the same visit.
- Replacement fixtures, if you go with a new faucet or valve.
Call or text (903) 458-4026, or text us a photo of the leak and we'll tell you what we see.
What customers say about our fixture work
★★★★★
"They fixed my faucet within just a few minutes. They were on time which is a big deal to me..."
Sheila E. · Google review
★★★★★
"gave me a great price for a new shower valve install."
Sandra B. · Google review
★★★★★
"they did an excellent job on my shower it looks amazing"
Mary L. · Google review
★★★★★
"Called OTW plumbing first thing in the morning with 2 leaking hose bibs... and a twisted water pipe leak under my home, they picked up on the first ring"
Liam F. · Google review
Faucet and Shower Valve Repair around Hunt and Rains counties
We handle faucet and shower valve repair for homes and businesses in Lone Oak and the towns around it, about a 60-mile radius from our shop. Pick your town below to see how we work there, or see all of our service areas.
Common questions
Got a drip, a bad shower valve or a leaking hose bib?
Call or text (903) 458-4026, or text us a photo of the leak. We'll tell you what it looks like and get you on the schedule.
